Multi Panel Configuration – Trim Wheel


Did you read this article? We will start at point 12 where we now will address the function of the Trim Wheel on the Saitek Multi Panel.

You should have had enough exercise with the previous configurations, so activate SPAD and get to the Trim page as in the image below. Set the acceleration slider to Max.

pmdgspad07

 

In FSUIPC set 64,6 to Elev Trim Dn and set 64,8 to Elev Trim Up

In both cases check the box Control to repeat while held

Done. Check the working in the Cockpit – Center Pedestal View

pmdgspad08

[Buttons.PMDG800]
1=P64,0,C66079,0
2=P64,1,C66080,0
13=P64,2,C65759,0
14=P64,3,C65758,0
19=R64,6,C65607,0
20=R64,8,C65615,0
4=P65,0,C65595,0
5=P65,1,C65603,0
9=R66,0,C65595,0
11=R66,1,C65603,0
16=P64,5,C65860,0
21=P1,1,C65567,0

 

Advertisements

Multi Panel Configuration – Flaps


pmdgspad04Did you read this article? We will start at point 12 where we now will address the function of the FLAPS UP and FLAPS DN on the Saitek Multi Panel

13. In SPAD press the Flaps tab in the menu screen SPAD- Multi Panel Configuration.
Set the values of the Up and DOWN position as in the image below.pmdgspad0314. Press Click (for UP) and set in FSUIPC the Joy# 64 2 Btn# to Flaps Decr
15 . Press Click (for  DOWN) and set in FSUIPC the Joy# 64 3 Btn# to Flaps Incr

 

pmdgspad05pmdgspad0616. Done! Check the function in the virtual cockpit.

17. Add the information to your Virtual Button List

 

[Buttons.PMDG800]
1=P64,0,C66079,0//gear up
2=P64,1,C66080,0//gear down
13=P64,2,C65759,0//flaps decr
14=P64,3,C65758,0//flaps incr